Inhibition of Radioactive Cobalt Deposition in Water-Cooled Nuclear Reactors

This invention relates to the operation and safety of water-cooled nuclear reactors, and in particular to methods to prevent the deposition of radioactive cobalt in the water-bearing vessels of such reactors.

A major hazard in water-cooled nuclear reactors is the accumulation of radioactive substances in the structural portions of the reactor. During reactor shutdown, for instance, workers are exposed to internal walls and tubing surfaces, and radioactive materials retained in oxide films which have accumulated on these surfaces are a major source of radiation exposure.

The introduction of certain metallic ions, including zinc, has been used to remove or lessen such deposition. The form and manner in which the zinc has been added, however, has had certain disadvantages. For instances, zinc has been added as a salt with anions which have been detrimental to the reactor, and the use of the active metallic ions before startup or during cleaning shutdowns has been of limited effectiveness in situations where long-term operation has occurred.

It has now been discovered that effective inhibition of radioactive cobalt deposition may be achieved by the continuous addition of zinc oxide to the water entering a water-bearing vessel of the reactor throughout the operation of the reactor. This provides the advantage of steady control of the radioactive cobalt accumulation, as well as efficient use of the zinc oxide, and total avoidance of the presence of anions harmful to the internal reactor surfaces.

The zinc oxide may be added in a variety of forms, examples of which are disclosed in detail below.

FIG. 1 is a flow diagram of one embodiment of the invention, designed to inject zinc oxide into the system in the form of a paste.

FIG. 2 is a flow diagram of the second embodiment of the invention, designed to add zinc oxide addition as a solution.

FIG. 3 is a flow diagram of the third embodiment of the invention, designed to add zinc oxide as a slurry.

In accordance with the present invention, zinc oxide is added to the water in water-bearing vessels which tend to accumulate matter deposited in films along their surfaces. The zinc oxide addition is done on a continuous basis throughout the operation of the reactor, providing a constant replenishment of zinc ion. A very small amount of zinc oxide will be sufficient to achieve inhibition of the radioactive cobalt deposition. The actual amount is not critical, however, and may vary over a wide range. For most applications, a concentration of from about 1 to about 1,000 ppb (parts per billion by weight), preferably from about 10 to about 100 ppb, maintained in the reactor water during operation of the reactor will provide the best results.

The invention may be applied to any waterbearing vessel in a nuclear reactor in which deposition of radioactive cobalt may occur. Such vessels may include tubes, shelves, feed and recirculation piping, and transfer and storage vessels in general. Recirculation piping is of particular concern, since it is a major source of exposure to plant workers during maintenance shutdowns. The zinc oxide may be added through feedlines to such vessels, or where appropriate, to recirculation lines branching off of such vessels.

The zinc oxide may be added in any form which permits it to be dissolved in the reactor water. Examples include slurries, pastes, and preformed solutions. When pastes or slurries are used, the zinc oxide is preferably in the form of a finely divided powder, fumed zinc oxide being most preferred. The zinc oxide contents in these pastes and slurries are not critical, since the concentration in the reactor vessels where the zinc oxide is needed may be controlled by the rate of addition of the paste or slurry to the incoming water. In most cases, paste will have zinc oxide contents ranging from about 25% to about 95% by weight, preferably from about 40% to 80%. Slurries will generally contain from about 0.1% to about 20% by weight, preferably from about 1% to about 5%.

The figures illustrate various ways in which the zinc oxide may be added.

In FIG. 1, the zinc oxide is added to the water-bearing vessel 10 by first combining the zinc oxide with water feed to the vessel through a feed conduit 11. Regulation of the flow rate through the feed conduit is achieved by a pump 12.

The arrangement shown in FIG. 1 is designed for the injection of a zinc oxide paste which is stored in a cylinder 13 fitted with an internal piston (not shown). For a nuclear reactor of typical size, it is contemplated that a typical cylinder size may be 3" (7.6 cm) in diameter and 20" (50.8 cm) in length. The shaft 14 of the piston is moved slowly forward by a motor-driven linear actuator 15. This may, for example, consist of an electric motor operating through a speed reducer and linear actuator moving at a rate of 0.001 inch (0.0025 cm) per minute.

As the piston moves to the left, the paste is forced out of the cylinder 13 through tubing 16. A stop valve 17 permits an operator to remove a depleted cylinder 13 without shutting down the feed line 11 or affecting the operation of the pump 12. A full cylinder may then be installed.

Rather than injecting the paste directly into the feed conduit 11, the paste is injected into a recirculation loop 18 which bridges a high pressure point 19 in the feed conduit (at the discharge end of the pump) with a low pressure point 20 (at the inlet or feed side of the pump 12). Circulation through this recirculation loop thus occurs in the clockwise direction in accordance with the arrangement shown in the drawing. An arrangement of static mixers 21 is positioned downstream of the injection point 22 where the paste from the cylinder 13 enters the recirculation loop 18.

In FIG. 2, the zinc oxide is added in the form of a solution formed by passing water through a bed of sintered zinc oxide pellets. Here, the flow arrangement is similar to that shown in FIG. 1--using a recirculation loop 30 branching off of a conduit 31 leading to the water-bearing vessel (not shown) sought to be protected from cobalt deposition. The conduit 31 may itself be a recirculation line or a feedwater line, and the flow rate through it is again controlled by a pump 32. The recirculation loop 30 brackets the pump 32. Water drawn into the recirculation loop enters a solid-retaining region 33 of the loop. This region contains solid zinc oxide with which water is in contact as it passes through. The region may be a trap, an expanded portion, or merely a segment of the piping closed off by screening or other construction designed to permit the passage of water while remaining solids.

Alternatively, the solid-retaining region may be a segment having walls lined with solid zinc oxide. It is preferred, however, that the zinc oxide be in particulate form, providing a high degree of surface area for contact between the water and the solid surface. A fixed or fluidized bed of zinc oxide particles may be used. The zinc oxide is preferably sintered, in pellets or a convenient shape. As the water passes through the pellet bed, it dissolves a portion of the zinc oxide, up to the solubility limit. A sufficient amount of zinc oxide may be charged to this retaining receptable to last the entire life of the reactor.

FIG. 3 demonstrates the addition of zinc oxide in the form of a slurry, using an alternative configuration. The slurry is supplied directly from a reservoir 40 in which the slurry 41 is maintained in substantially homogeneous form by a stirrer 42. A pump 43 delivers the slurry at a fixed preselected rate to a flow conduit 44 which supplies water to the water-bearing vessels sought to be protected. As before, the relative flow rates of water through the flow conduit 44 and slurry through the pump 43 will determined the final concentration of dissolved zinc in the water-bearing vessel.

The present invention is applicable to water-cooled nuclear reactors in general, including light water reactors and heavy water reactors. The invention finds particular utility in pressurized water reactors and boiling water reactors.

The foregoing is offered primarily for purposes of illustration. It will be readily apparent to those skilled in the art that numerous modifications and variations of the features of construction and operation disclosed herein may be made without departing from the spirit and scope of the invention.